The cylinder valve opening may be damaged. Burrs, fractures, pits, dents etc. in the mouth of the valve. Should not be. In addition, if the union seal of the pressure reducer is damaged, it must be replaced.

Standard pressure reducers cannot provide sufficient output flow for multiple tubes. Therefore, high flow pressure reducers should be used for multiple tubes.

No! The pressure reducer suitable for the type of gas to be used must be used!

High flow pressure regulators should be used in the group of tube outlets.

The red zone on the manometers indicates that the operating pressure should not be within this zone and should not exceed this zone.

No. The handle does not change according to gas type. Welding to be connected to handle, annealing or gas type for cutting torches.

The nozzle connection nut and handle connection nut of the cutters must be tightened and not loose. In addition, the operating pressures to the circuit breaker must be checked.

In case of blockage at the burner tips, blockages can be opened by the user using nozzle needles prepared for these burners.